There are several ceiling texture choices to choose from when finishing a room. You
can simply apply a flat paint to the ceiling, or spray or roll on a popcorn
textured ceiling. However both these choices seem to be waning in popularity to
the Skip Toweled look. The Skip Troweled look provides a compromise between the
flat painted ceiling and the popcorn ceiling. It provides texture but to a lesser
extent than a traditional popcorn ceiling. Skip Troweling should be performed after the sheetrock, mudding and taping are complete. Skip Troweling simply involves applying water downed Joint Compound onto the ceiling and running a trowel over it once. To Skip Trowel a ceiling, simply water down a batch of Joint Compound to a soupy consistency. Then using a trowel (the pros use a sprayer for large areas) simply spread the material onto the ceiling. Note that this is a very messy job as there will be significant spillage and dripping. Consequently protect yourself and your floors with eye-protection and plastic on the floors. If the Joint Compound is of the right consistency the material applied onto the ceiling will begin to form stalactites that dangle from the ceiling. Not too worry as this is what you want to occur. After the joint compound has begun to dry somewhat, use your trowel to knock off the high points (the stalactites). To do this, simply run your trowel over the now partially stiff joint compound area. The completed surface will have a mottled look. Let the Joint Compound completely dry then paint the ceiling using a roller. When employing the Skip Trowel method you can get creative by adding fine sand to the Joint Compound mixture before applying to the ceilings, or by moving the Trowel in a swirling pattern when applying the compound. In addition, some of the pros actually mix paint with the soupy Joint Compound mixture to eliminate the need for applying paint after the material has dried. About the Author: Over the past 20+ years Mark Donovan has been involved with building homes and additions to homes. For more information about Home Improvement and Home Additions, and Home Remodeling and Repair visit homeadditionplus.com and homeaddition.blogspot.com Article Source: http://EzineArticles.com/?expert=Mark_Donovan |
• |
• |
• |
• |
For The Do it Your Self Homeowner |
©2005 |
* |
* |
Drywall Repair Tips |
– Drywall F.A.Q – |
• |
• |
• |
• |
• |
• |
• |
• |
• |
• |
• |
• |
• |
• |
©2005 • 2008 |
• |
• |
• |
• |
• |
• |
how to apply skip trowel texture to a wall |
Search Vertri.com |
• |
• |
• |
This program will calculate the amount the amount of sheetrock needed to drywall
an area or a room..more |
Hang drywall on ceilings before walls, so the sheets on the walls can help support the corners of the ceiling sheets.... more information |
Planning your installation Careful!..Finishing corners..Smoothing and priming drywall..Time frame.... more information |
Apply drywall to leave the fewest possible joints....more information |
On ceilings, use annular ring nails or drywall screws to fasten drywall panels to joists. On walls, use drywall nails or screws to attach panels to studs, top plate,
and bottom plate... more information |
provides a chart for estimating the number of 4x8 sheets of drywall required for
paneling rooms of various sizes...more |
If the drywall is being applied horizontally, install all top boards first...more |
Use a 4" joint finishing knife to smooth out each coat of joint compound. Fill
in the slightly recessed area created...more information |
Drywall Repair |
Search Vertri.com |
Drywall Repair |
Skip Troweling Method For Textured Ceilings By Mark Donovan |
Skip Troweling is relatively simple to do and can be performed by a homeowner who
is doing a home addition project. |